P50 Pro Electrode to bring a worn meter back: a direct-fit pH and temperature sensor from Aqua Master Tools. When an Aqua Master Tools P50 Pro starts giving slow or unstable readings that calibration no longer fixes, the sensing end has usually worn out, not the meter. This pH and temperature electrode (AMT1001) replaces that end on the P50 Pro, so the body, display and buttons carry on in service. Once it is screwed in and sealed, the meter is again IP67 waterproof. Fitting takes a few minutes: undo the sealing ring under the meter, ease the old electrode out, line the recess of the new one up with the connectors, make sure the rubber seal is seated, then tighten the ring and calibrate. Published instructions call for pH 7.00 and 4.01 buffers for that calibration.
| Specification | Value |
|---|---|
| Brand | Aqua Master Tools |
| Item number | AMT1001 |
| For meter | P50 Pro |
| Waterproof rating | IP67 with the electrode attached |
| Reads | pH and temperature |
| Calibration | pH 7.00 and 4.01 buffers |
| Pack | Each |
| Barcode | 8785258333705 |
This electrode is the match for the P50 Pro pH and temperature pen. For the other pen, see the P110 Pro 2 electrode. If you have any questions about this P50 Pro electrode, contact us at support@groindoor.com or through chat.
Everything needed to confirm fit is on this page — add it to your cart to see delivered pricing for your address.
Soak the new tip briefly in storage solution, calibrate at pH 7.00 and then 4.01, and park it in KCl storage solution between readings.
No; the P50 Pro electrode reads pH and temperature only.
It is made for the P50 Pro; other models take their own electrodes.
Yes; with the electrode attached it is rated IP67.
Yes; run a fresh calibration with pH 7.00 and 4.01 buffers.
| Lead Time | This product ships in 1-3 Business Days |
|---|---|
| EACH - Height(in) | 1.18 |
| EACH - Length(in) | 3.58 |
| EACH - Width(in) | 1.18 |
| Height (in) | 1.18 |
| UPC | 8785258333705 |
| Width (in) | 1.18 |
| Brand | Aqua Master |